Iai-america ISPDACR-ESD Manual de usuario descargar pdf (Pagina 43)

5. Installation

5.5 Using T-slots

M4 T-slots are provided on the side face of the base for installing the connector box or other item that must

be combined. (See the figure below.)

If a wiring kit is combined, use these T-slots to install the kit.

You can also use these T-slots freely for installing sensors, securing wires or for other purposes as

necessary.

Caution: Square nuts are recommended for use with T-slots, but general hexagonal nuts can also be

used. When installing bolts in T-slots, pay attention to the length of each bolt to prevent the

bolt tip from contacting the bottom of the T-slot.

Distance

from bolt tip

Square nut

(or hexagonal nut)

Installed

part

Bolt

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 125 126

Sin comentarios

Iai-america ISPDACR-ESD Manual de usuario Pagina 43