Iai-america RCM-P Manual de usuario Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 68
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
10
8. Operation
(1) Positioner (PCON-PL/PO, ACON-PL/PO, SCON: Mode other than the Pulse Train Mode)
The total picture of operations performed with the RC Data Input Pendant has the tree structure as
shown below. To return to the previous screen, press the ESC key.
Rated speed only MAX
Position
Vel
A
cc/Dcl
Push
Range
BS/INC
CTL error list
- Error No.
- Message
Power-ON
Confirming connection
Axis Select
Operation
Start/End
Mode Select
Edit/Teach
Monitor
Error List
Error No.
Message
A
xis No.
Minutes ago
occurrence
Return
Return
Return
End
* You will be able to change
to the “Operation Start/End”
screen from any other
screen by using the
BEGIN/END key.
Please, press the
BEGIN/END key for
more than 2.5
seconds.
* Confirm whether to reset software when
going through the mode with the
key if changing the parameter. (Only for
PCON, ACON, SCON, RCP2, ERC, ERC2)
Reconnect
Return
Position
Vel
Dcl
Push
LoTh
A
cc
Range
Zone +
A
cc/Dcl Mode
BS/INC
Cmnd Mode
Zone -
Stop Mode
A
ll Clea
r
Clear
* This is indicated
only when two or
more axes are
connected.
Servo OFF
confirmation
Software
reset
User
Parameter
A
djustment No.
Distribution No.
* Only PCON, ACON, SCON
and ERC2 are allowed.
* Content to be indicated may depend on
type and version of controller to be
connected, version of RC DATA Input
Pendant.
TP operation
mode
User
Adjustment
TP operation mode
* Displayed only for PCON, ACON, SCON, and ERC2.
ESC
ESC
ESC
Return
ESC
ESC
MDI
Direct each
Incorporate
PCON, ACON,
SCON, ERC2.
RCP,RCS, E-CON,
RCP2, ERC.
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

Comentarios a estos manuales

Sin comentarios