Iai-america SSPDACR Manual de usuario descargar pdf (Pagina 45)

6. Installation

6.3 Installing the Load on the Slider

x The slider has two types of threaded holes, so affix the load using these holes. The affixing method shall

conform to the method for installing the actuator.

x Similarly when the slider is affixed and actuator is moved, install the slider using these threaded holes on

the slider.

x The slider has two reamed holes. If repeatability is required after removal/re-installation, use positioning

pins. If squareness is required, use one positioning pin and make installation adjustment.

x After removal/re-installation, repeatability can also be ensured by pushing the reference surface on the side

of the base.

x Use high-tension bolts conforming to ISO 10.9 or higher.

x When the threaded holes are used, determine the required thread length as specified below:

x ISDB, ISPDB, ISDBCR, ISPDBCR

Depth of threaded hole > Thread engagement length > Nominal thread size x 1.8

x SSPDACR

Depth of threaded hole > Thread engagement length > Nominal thread size

z ISDB, ISPDB, ISDBCR, ISPDBCR

Slider reference surface

(

top

)

Thread B

Thread A

Reamed hole C

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 115 116

Sin comentarios

Iai-america SSPDACR Manual de usuario Pagina 45