Iai-america E-Con Manual de usuario descargar pdf (Pagina 19)

3. X-SEL-J/K/P/Q/JX/KX/PX/QX

(*1) The CC-Link board installation position is the same as Fig. 3-1-1 for four axes specifications.

(*2) The CC-Link board installation position is the same as Fig. 3-1-2.

(*3) The CC-Link board installation position is the same as Fig. 3-1-3. The CC-Link board installation position for five axes and

six axes specifications are the same as the four axes specification.

(Note): 16 points each for input and output among I/O points are in the system area of the remote device station, therefore, these

points cannot be used.

For details, please refer to “3.1.7 Correspondence between X-SEL I/O port number and PLC address.”

(1) Compact type (J type)

For single axis For two axes For three and four axes

Note: For items of single axis and two axes, a PIO board cannot be installed. For those of three and four axes, an expansion

I/O board

(*1)

can be inserted into the expansion slot.

Fig. 3-1-1

CC-Link board CC-Link board Expansion slot CC-Link board

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 151 152

Sin comentarios

Iai-america E-Con Manual de usuario Pagina 19