Iai-america PCON-CFA Manual de usuario descargar pdf (Pagina 174)

4. SCON-CA

166

4.5 Setting

Using the teaching tool, set controller parameters. Set the mode toggle switch on the front panel of the

controller to “MANU” side. The versions of teaching tool compatible with EtherNet/IP are as follows:

x RC PC-compatible software: V8.01.01.00 or later

x CON-T/TG: V1.10 (Planned)

x CON-PT/PD/PG: V1.20 (Planned)

x RCM-E/P: V2.20 (Planned)

4.5.1 Operation Mode Selecting

Set parameter No. 84 “FMOD: Field bus operation mode.”

[Refer to 4.9 EtherNet/IP Related Parameters.]

Set value Operation mode

Number of

occupied bytes

0 (Factory setting) Remote I/O mode 2

1 Position / Simplified direct value mode 8

2 Half direct value mode 16

3 Full direct value mode 32

4 Remote I/O mode 12

5 Position / Simplified direct value mode2 8

6 Half direct value mode 2 16

7 Remote I/O mode 3 12

8 Half direct value mode 3 16

* Entering any value except for the ones described above will cause an “Excessive Input Value Error”.

4.5.2 Setting the Baud Rate

Set parameter No. 86, “FBRS: Fieldbus baud rate.”

Set value Baud rate

0 (Factory setting) Auto negotiation (recommended)

1 10 Mbps, half-duplex

2 10 Mbps, full-duplex

3 100 Mbps, half-duplex

4 100 Mbps, full-duplex

Other than the above Baud rate setting error

1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 293 294

Sin comentarios

Iai-america PCON-CFA Manual de usuario Pagina 174