Iai-america PCON-CF Manual de usuario descargar pdf (Pagina 9)

CAUTION

[2] Enabling/disabling the servo ON input signal (SON)

The servo ON input signal has been added to allow for servo ON/OFF control on the PLC side.

Depending on the needs, therefore, the user must enable/disable this signal.

To select a desired setting, set “0” or “1” in parameter No. 21 (Servo ON input disable selection).

Enable (use) 0

Disable (do not use) 1

The factory setting is “0 [Enable].”

[3] Enabling/disabling the pause signal (*STP)

The pause signal uses the contact b logic to provide a failsafe function.

Therefore, this signal must remain ON in normal conditions of use.

Since there are applications where this signal is not used, a parameter is provided to disable the pause

signal so it doesn’ t have to be turned ON.

To select a desired setting, set “0” or “1” in parameter No. 15 (Pause input disable selection).

Enable (use) 0

Disable (do not use) 1

The factory setting is “0 [Enable].”

5. Using a Rotary Actuator in Multi-rotation Specification

Rotary actuators of multi-rotation specification models let you select multi-rotation operation or limited-rotation

operation using a parameter.

5.1 Notes

Pay attention to the setting of the PIO pattern parameter for the controllers specified below.

Each controller does not support relative coordination specification in the PIO pattern specified.

[1] PCON-C/CG: PIO pattern = 5 (User parameter No. 25)

[2] PCON-CY: PIO pattern = 0 (User parameter No. 25)

5.2 Applicable Models

*-IP82-C-NOCP*-063-02-P82-I-LBTR-2PCR

*-IP82-GC-NOCP*-063-03-P82-I-LBTR-2PCR

*-IP82-YC-NOCP*-063-02-P82-I-LCTR-2PCR

Actuators

RCP2-RTCL-I-28P-30-360-*

Controllers

PCON-SE-28PI-*

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 225 226

Sin comentarios

Iai-america PCON-CF Manual de usuario Pagina 9