Iai-america PCON-CFA Manual de usuario descargar pdf (Pagina 23)

2. ACON-C/CG, PCON-C/CG

2.5 Selecting (Setting) the Operation Mode

The operation mode is set using a parameter.

Set the mode selector switch on the front panel of the controller to the MANU position, and set parameter No. 84,

“FMOD: Fieldbus operation mode” using the RC PC software (V6.00.05.00 or later). (Refer to 2.10, “DeviceNet

Parameters.”)

Set value Operation mode

Number of occupied

stations

0 (Factory setting) Remote I/O mode 1CH

1 Position/simple direct mode 4CH

2 Half direct mode 8CH

3 Full direct mode 16CH

4 Remote I/O mode 2 6CH

* If any other value is entered, an excessive input error will occur.

2.6 Setting the Node Address

The node address is set using a parameter.

Set parameter No. 85, “NADR: Fieldbus node address” using the RC PC software. (Refer to 2.10, “DeviceNet

Parameters.”)

Allowable setting range: 0 to 63 (The parameter has been set to “63” at the factory.)

(Note) Exercise caution to avoid node address duplication.

The nodes (controllers) are assigned in the order of their node address in the remote I/O address areas of

the PLC. (This is when the mount assignment mode is selected. A different rule applies when a

configurator is used.)

For details, refer to the operation manuals of the master unit and PLC installed in the master unit.

(Note) The baud rate is automatically set to the same value as the baud rate set in the master. Accordingly, you

need not set the baud rate.

(Note) After you have set the parameter, reconnect the controller power and return the mode selector switch on

the front panel of the controller to the AUTO position. If the switch remains in the MANU position,

operation by the PLC cannot be performed.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 265 266

Sin comentarios

Iai-america PCON-CFA Manual de usuario Pagina 23