Iai-america RCS2-A6R Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 72
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
2. Installation
31
2.3.4 Attachment of the Transported Object
Use four M4 screws to install the transported object to the slider.
Caution: Check to see that the workpiece seating surface is flat to prevent the slider from
becoming deformed when the workpiece is installed.
Slider deformation may cause it to move rigidly or shorter its life.
Caution: Do not exceed the maximum mass capacity.
Please make note of the slider moment, allowable overhang length and load
weight.
Tapped hole to install
the work
p
iece
Slider
Slider
Workpiece
A
Set the dimension of an overhang above the
workpiece to the value shown below to prevent
interference with the screw cover and workpiece.
Type Size
A4R A=53mm
A5R A=65mm
A6R A=70mm
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 71 72

Comentarios a estos manuales

Sin comentarios