Iai-america RCS2-A6R Manual de usuario descargar pdf (Pagina 52)

4. Maintenance Inspection

(3) Loosen the motor-unit affixing bolts using an Allen wrench of 3mm across the flats.

�

(4) Check the following points before restoring the home position:

� The motor side should be aligned with the initial countermark. If the position is offset, adjust

it to achieve proper alignment.

� The ball screw side should be at a position where the slider projects A4R is 0.6mm, A5R

and A6R is 0.7mm from the mechanical end.

After the check, attach a new belt while holding the pulleys on both sides in position.

�

Initial countermark

position

Corresponding to the slider position

of 0.6mm away from the

mechanical end for A4R or 0.7mm

away for A5R and A6R

Motor side Ball screw side

Motor-unit affixing bolts

(Use an Allen wrench of 3mm across flats.)

Motor-unit affixing bolts

(Use an Allen wrench of 3mm across flats.)

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 71 72

Sin comentarios

Iai-america RCS2-A6R Manual de usuario Pagina 52