Iai-america PCON-CFA Manual de usuario descargar pdf (Pagina 27)

3. ACON-C/CG, PCON-C/CG

CC-Link

(1) PLC Address Composition (* “n” shows the head register address for each axis).

Parameter

No.84

Acon or Pcon side

DI (Port No.)

PLC side

Acon or Pcon side

DI (Port No.)

PLC side

0 to 15 RY n0 to nF 0 to 15 RX n0 to nF

System Area RY (n+1)0 to (n+1)F System Area RX (n+1)0 to (n+1)F

RWw (n+0) RWr (n+0)

RWw (n+1) RWr (n+1)

RWw (n+2) RWr (n+2)

Occupied Area

RWw (n+3)

Occupied Area

RWr (n+3)

Note: The Occupied Area stands for the area occupied by means of the setting of the number of remote device

stations.

The System Area stands for the system area of the remote device station.

These areas are not used for any other purpose. Also take care about duplicating the use of the data register.

(2) I/O Signal Allocation for each Axis

The I/O signals for each axis consists of 1 word for each I/O bit register.

z The I/O bit register is controlled using the ON/OFF signal in units of bit.

PLC Output (* “n” shows the head register address per each axis).

Address one word = 16 bits

RY (n+0) F E D C B A 9 8 7 6 5 4 3 2 1 0

Controller

Input Port

No.

PLC Input (* “n” shows the head register address per each axis).

Address one word = 16 bits

RX (n+0) F E D C B A 9 8 7 6 5 4 3 2 1 0

Controller

Output

Port

No.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 103 104

Sin comentarios

Iai-america PCON-CFA Manual de usuario Pagina 27